10/11/2023 0 Comments Cura cetus3d update![]() I have better results with lower flow rates (dia 0.4 or 1900%), but more testing needs to be done. Filament diameters of around 0.38 translate to the 2200% cmeyer posted (flow rate factors in quadratic, so use fine steps when adjusting it). Flow rate percentage adjustments mess up the ‘layer view’ in Cura (from years of experience with an Ultimaker 2, I find this one of the most helpful features in Cura). Keep in mind that you may have to find a physical solution for levelling the build bed when using Cura.ĭ) With the current version of Cura (v3.3.1) it is better to adjust the flow rate of molten filament via the filament diameter, than the flow rate percentage. The nozzle is too far away from the bed, if the individual lines can be easily separated and do not stick together.)Ĭ) Up Studio allows for an 9-point calibration routine for the z-axis. The nozzle is too close to the bed, if the brim thickness (z-direction) gets to thin and translucent. If you use a brim around a test-model in Cura, the correct height is achieved, if the individual lines that make up the brim squash together nicely. cetus3d/comments/108nbpb/cetus2problems/ Cetus ROM Update (NOT firmware) Tiertime Help Center Cetus2 Cura Profile Cetus3D Web3 years ago. (I think a painfully precise calibration is overkill. I did compile my ‘own version’ from the start code by chrisevich. Perhaps the info below will help someone in the future:Ī) I used the start and end code from chrisevich ( #11) which worked nicely for me.ī) the z-axis calibration code posted by cmeyer never worked for me. Introduced Hole Horizontal Expansion Max Diameter so only the expansion of smaller holes can be tuned while leaving larger holes untouched. Added support for the updated mainboard revisions of UltiMaker S3, S5, and S7. I just wanted to thank everyone who contributed to this thread - it helped me tremendously when setting up my Cetus3D MkII with Cura. Other new features and improvements: Updated the UltiMaker logo to reflect the new company logo. G1 X50 E360 F300 extrude a 5cm purge line ![]() G1 X2 Y178 F5000 move to back right corner M206 X-180 offset X axis so the coordinates are 0.180, normally they are -180.0 Do the paper test and use a gcode file something like this:p.p1 the nozzle offset may be different than in Cetus Studio. The Tiertime Cetus extended version is the same size as the standard MK3 in length and width, but the height is significantly different at 16.8 inches in comparison to the standard’s 10.75 inches. make sure your nozzle offset is correct in the starting g-code There are some 3D printed parts and the printer is boasted to be mod-friendly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |